770/GS/GJ-BA-defsi-0023 99
3.5.5 Data ID Codes
To help you identify weights, piece counts, percentages, etc., a code letter is displayed
in front of these values. For example, an “N“ displayed in front of a weight value
identifies it as a net weight. Without data ID only net weights, results in percent and
counting results will be output. You will find the data ID codes for a particular application
program listed in the corresponding description. The ID code increases the data output
format for each weight readout from 16 to 22 characters.
ID code for data output Code
Without 7 2 1*
With 7 2 2
3.5.6 Automatic Output of the Tare Memory Data
If you have selected the application program „tare memory“ (2 1 6), you can have your
choice of values output by pressing the
F
key.
Code
Last net value (individual value N 1) 7 3 1*
Tare memory data (total T1) 7 3 2
3.6 Additional Functions
Functions Code
Print 8 4 1*
Tare 8 4 2
Adjust/linearise (using CAL) 8 4 3
F key 8 4 4
CF key 8 4 5
* = factory setting
To Next Page
Loading...
Need help?
General
