CK2810 / CK3010H
5
-
24
CONNECTING AND DISCONNECTING IMPLEMENT
CONNECTION
1. Make sure to stop the engine be-
fore connecting implements.
2. Move the double acting valve le-
ver forward and backward for 4
to 5 times to release the pressure
in the hydraulic line of the tractor.
Otherwise, it is hard to connect the
couplers,andhydraulicuidcanbe
sprayed from the line and get in to
your eyes while connecting them.
3. Re mo ve an y fo rei gn m ate ria l
around the male and female cou-
plers. If foreign material enters the
hydraulic components, it can lead
to malfunction of the system.
4. Open the dust-proof cover of the
female coupler of the tractor and
insert the male coupler of the im-
plement. A clicking sound is heard
when the couplers are engaged.
5. Pull the hydraulic hose of the im-
plement to check that the couplers
are properly connected.
6. Start the engine and check the op-
erating status and leakage.
DISCONNECTION
1. Make sure to stop the engine before
disconnecting implements.
2. Release any residual pressure in the
hydraulic hoses of the implement
and tractor by operating the double
acting valve lever 4 to 5 times.
3. Remove any foreign material around
the couplers.
4. Lower the implement on the ground
or remove any external load applied
to the implement. Disconnecting
hoses while outer load is applied to
the implement is very difficult and
dangerous due to the pressurized
uidinthehose.
5. Remove the male coupler by push-
ing the female coupler boss back-
ward.
6. Close the dust-proof cover of the
female coupler. Wrap the male cou-
pler of the implement with a plastic
bag to prevent contamination.
Never connect or disconnect
the implement hydraulic hose
while the pressure in it is not
released or the engine is run-
ning. It is hard to connect and
disconnect the hose and hy-
draulic fluid can be sprayed
from the hose, and get into
your eyes or skin.
Stop the engine and wear pro-
tective glasses and gloves be-
fore work.
•
•
WARNING
To Next Page
Loading...
Need help?
General
