KEY SWITCH
(1) Key Switch (A) Pre-heat (B) Stop
(C) ACC (D) ON (E) Start
(A)
The position "A" indicates the
"manual preheat". This position
is a self-return type, so the key
should be held there while pre-
heating. The pre-heating indication
lamp on the dash board will turn
on at the same time. Pre-heating
more than 30 seconds consecu-
tively can reduce the preheat
system’s life.
The pre-heating operation will
automatically be activated in this
position "D" (ON).
The automatic
preheat operation is indicated
by the glow plug indicator. Make
sure to preheat the engine un-
til the glow plug indicator goes
off (approx. 9 seconds) in cold
weather.
•
NOTE
(B)
When the key switch is in position
"B", the engine and all electrical
devices in the vehicle are turned
off.
However flasher lights and turn
signal lights can be operated along
with their indication lamps on the
dash board.
ACC (C)
When the key switch is turned
to the position "C", brake lights,
asher lights and turn signal lights
can be operated.
(D)
The position "D" indicates the "ON"
position.
As soon as the key switch
is turned to this position, the oil
pressure warning lamp and battery
charge warning lamp comes on
(These turn off after the engine is
started).
(E)
The position "E" indicates "Start".
In order to start the engine, de
-
press the clutch pedal and turn the
PTO switch off.
As soon as the engine is started,
release the key then the key will
return to the position "D".
TE1O405A
To Next Page
Loading...
Need help?
General
