TP-7044 6/23 101
Section 5. Wiring Diagrams
Accidental starting.
Can cause severe injury or death.
Disconnect the battery cables before working on the generator set. Remove the
negative (–) lead first when disconnecting the battery. Reconnect the negative (–)
lead last when reconnecting the battery.
Disabling the generator set. Accidental starting can cause severe injury or death. Before working on the generator set or
equipment connected to the set, disable the generator set as follows: (1) Press the generator set off/reset button to shut down
the generator set. (2) Disconnect the power to the battery charger, if equipped. (3) Remove the battery cables, negative (–) lead
first. Reconnect the negative (–) lead last when reconnecting the battery. Follow these precautions to prevent the starting of the
generator set by the remote start/stop switch.
Hazardous voltage. Moving parts.
Will cause severe injury or death.
Operate the generator set only when all guards and electrical enclosures are in place.
Grounding electrical equipment. Hazardous voltage will cause severe injury or death. Electrocution is possible whenever
electricity is present. Ensure you comply with all applicable codes and standards. Electrically ground the generator set, transfer
switch, and related equipment and electrical circuits. Turn off the main circuit breakers of all power sources before servicing the
equipment. Never contact electrical leads or appliances when standing in water or on wet ground because these conditions
increase the risk of electrocution.
Disconnecting the electrical load. Hazardous voltage will cause severe injury or death. Disconnect the generator set from
the load by turning off the line circuit breaker or by disconnecting the generator set output leads from the transfer switch and
heavily taping the ends of the leads. High voltage transferred to the load during testing may cause personal injury and equipment
damage. Do not use the safeguard circuit breaker in place of the line circuit breaker. The safeguard circuit breaker does not
disconnect the generator set from the load.
To Next Page
Loading...
Need help?
General
