EasyManuals Logo
Home>Kohler>Engine>KD400

Kohler KD400 Workshop Manual

Kohler KD400
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
13
5
5
5
- 70 -
STORAGE
Internal engine protection:
-Starttheengineandallowittoheatup.
-Removethedrainplugandlettheoilowoutcompletely.
-Replacetheoillterwithanewone.
- Clean the oil drain plug and after inserting a new gasket,
tightenit.
- Fill up with oil to the upper level of the dipstick, usingAGIP
RUSTIA C30 (for countries in which this product is not
availablendanequivalentproductonthemarket).
-Starttheengineforabout10minutes,checkforoilleaks,and
thenstoptheengine.
Injection systems protection:
-Emptythefueltank.
-Replacethefuellterwithanewone.
-Fillupwithfuelcontaining10%AGIPRUSTIANT.
-Afterbleedingair,starttheengine,makesuretherearenofuel
leaksandthenstoptheengine.
External engine protection:
- Carefully clean the cylinder cooling system ns and the
ywheelns.
- Protect the external non-painted surfaces withAGIP RUSTIA
68/F.
-Sealtheintakeandexhaustsystemswithadhesivetape.
-Covertheenginewithanylonorplasticsheet.
-Storeinadryplace,preferablynotdirectlyonthegroundand
awayfromhighvoltageelectricitylines.
STORAGE
When the engines are not used for more than 3 months, they must be protected by the measures described
below:
KD 225_315_350_400_440 Workshop Manual_cod. ED0053029330_1° ed_ rev.00

Table of Contents

Other manuals for Kohler KD400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler KD400 and is the answer not in the manual?

Kohler KD400 Specifications

General IconGeneral
BrandKohler
ModelKD400
CategoryEngine
LanguageEnglish

Related product manuals