TT-1403 4/16 11
7.2 Programming the Exercise Cycles
Use the procedures in the following sections to program
up to 8 on/off events for each day of the week.
After all exercise cycles have been programmed, slide
the RUN switch to the RUN position. The clock colon will
blink.
7.2.1 Day Selection
For each on or off cycle, you will need to set the day or
days of the week. To save time you can set up each
on/off cycle for one day, Monday through Friday,
weekends only, all days except Sunday, or the entire
week. This can save a lot of time when programming the
on and off cycles.
1. Slide the RUN switch to P.
2. Press the 17 button seven times and notice a
single arrow will move in steps below the 1--7
numbers, indicating the individual days of the week
3. Press the 17 button again to see days 1 to 5
highlighted with arrows (Monday through Friday).
4. Press 17 again to see arrows highlighting 6 and 7
(weekends).
5. Press 17 again to see arrows highlighting all
days except Sunday.
6. Press 17 again to see arrows highlighting all
days of the week.
7.2.2 Programming an ON cycle
1. Slide the RUN switch to P. The lower number 1
indicates this is the first switch cycle and a bulb icon
indicates a switch on condition (circuit closes).
Note: Odd numbers indicate a switch-on cycle.
2. Press the 1....7 button until arrows point to selected
day(s) you want this ON cycle to occur. See Section
7.2.1, Day Selection, for instructions to choose
days of the week.
3. Press the h and m buttons to show the desired
switch-on time, noting the AM/PM indicator.
Note: After each ON cycle, be sure to program a
corresponding OFF cycle for the same days of
the week.
7.2.3 Programming an OFF cycle
1. Slide the RUN switch to P. Press the P button. The
switch cycle number changes to 2 and the bulb
blinks, indicating switch-off (circuit opens).
Note: Even numbers indicate a switch-off cycle.
2. Press the 1...7 button until the arrows point to the
selected day(s) you want this OFF cycle to occur.
3. Press h and m buttons to select the switch-off time.
To program another exercise cycle, press the lower P
button to advance to the next cycle and return to step 2
of Section 7.2.2.
After programming the on and off cycles, slide the RUN
switch to the RUN position. The clock colon will blink.
7.2.4 Setting error
If EEE appears, a setting error exists. The switch cycle
number in error is shown.
1. Slide set switch to P.
2. Press P button until the cycle with the error is
shown. Review this and the next setting and correct
the error.
3. Slide the set switch to RUN.
7.2.5 Clear any setting
1. Slide the RUN switch to P.
2. Press the lower P button to move to the switch on
cycle you want to clear.
3. Press the P and X—> (skip) buttons
simultaneously and hold until the time display
shows 00:00. Repeat for the corresponding switch
off cycle. This on/off cycle is now inactive.
7.2.6 Clear all settings
To erase all settings, press R.
To Next Page
Loading...
Need help?
General
