Komatsu D65PX-12 Service Manual

EXPLANATION OF COMPONENTS OPERATION
3-28
ELECTRIC POWER TAKE-OUT ADAPTER
NOTICE
● Do not use as a power supply for 12V equipment.
This will cause failure of the equipment.
● When using as a power supply pickup, do not install equipment which exceeds 120W (24V x 5A).
1. Open battery cover (1) on the left side of the machine.
2. Pull out the electric power take-out connector for the cab.
(A single-pole connector CN24 (2) for an optional device
can be used.)
Connector CN24 (2) is secured to the main harness with
a band. When using CN24, remove it. After using it,
secure it with the band again.
Capacity of each connector: 480W (24V x 20A)
Machine equipped with cab
It is possible to remove the cigarette lighter and use the socket as a power supply.
Capacity of cigarette lighter: 120W (24V x 5A)
REMARK
● Ground the negative wire to the body work or ROPS. Do not ground it to the rubber mounted engine or
valves.This will cause failures.
● If the wire is grounded to a point where there is still paint, the electricity will not flow smoothly, so remove the
paint.

Komatsu D65PX-12 Specifications

General

Brand	Komatsu
Model	D65PX-12
Category	Construction Equipment
Language	English