2524 Recording - basic operation
LCD MONITOR DISPLAY
Image size (p. 44)
Image quality (p. 44)
Focus signal (p. 29)
Recording mode
Flash modes (p. 28)
Focus frame
Battery-condition indicator (p. 18)
Frame counter
Drive mode (p. 40)
USING THE ZOOM LENS
This camera is equipped with a unique 7.7 - 23.1mm zoom lens. This is equivalent to a 37 to
111mm lens on a 35mm camera. The lens is operated by the zoom lever at the back of the camera.
To zoom in on the subject, push the the right side
(T) of the zoom lever (1).
To zoom out, push the the left side (W) of the zoom
lever.
After zooming, the zoom indicator is displayed on
the LCD monitor to show the approximate zoom
position.
The digital-zoom function can increase the power of
the lens. The digital zoom is activated in section 3
of the recording menu (p. 55).
Zoom indicator
1
Place the subject anywhere within the focus frame. Make sure the
subject is within the focus range of the lens (p. 26). For very close
subjects, use the Super Macro function (p. 31).
BASIC RECORDING OPERATION
Press the shutter-release button partway down to lock the focus
and exposure.
The white focus signal confirms focus. If the focus signal is red, the
camera was unable to focus. Repeat the previous steps.
Press the shutter-release button all the way down to take the pic-
ture. The recorded image can be previewed by continuing to hold
down the shutter-release button after the image is captured. The
instant-playback function can also be used (p. 51).
The indicator lamp blinks to show data is being written to the mem-
ory card. Never remove or insert a memory card while data is being
transferred.
Focus signal
Focus frame
Camera-shake warning (p. 30)
Anti-Shake indicator (p. 47)
To Next Page
Loading...
Need help?
General
