25
BASIC RECORDING OPERATION
Press the shutter-release button partway down (1) to lock the
focus and exposure.
• The focus signals (p. 27) on the monitor will confirm that the image
is in focus. If the monitor focus signal is red, the camera was
unable to focus on the subject. Repeat the previous steps until the
focus signal is white.
• If the battery power is very low, the LCD monitor turns off when
flash charges.
Press the shutter-release button all the way down (2) to take
the picture.
• After the shutter releases, the indicator lamp next to the card slot
will turn
red and blink indicating image data is being written to the
memory card. Never remove a memory card while data is being
transferred.
• The image can be previewed after it is captured by continuing to
hold down the shutter-release button (p. 59).
Turn the camera on and slide the recording-mode switch to the recording
position.
1
Place the subject within the focus frame on the LCD monitor.
•T
he focus-lock function (p. 26) can be used with off-center
subjects.
2
To Next Page
Loading...
Need help?
General
