98 DATA-TRANSFER MODE
PictBridge allows still images on the memory card to be printed directly from a PictBridge-
compatible printer. The maximum number of images that can be specified for printing is
50. To use PictBridge, the transfer-mode option in section 3 of the setup menu must be
set to PictBridge.
Before each print run, check the printer settings; refer to the printer manual. If the date
has already been imprinted on the images with the date-imprinting (p.56) function, or the
DPOF date printing (p. 76) is on, the PictBridge data-print function prints an additional
date. A fully charged battery should be used when the camera is connected to the printer.
The use of the AC adapter (sold separately) is recommended over the use of the battery.
USING PictBridge
CHANGING THE MEMORY CARD - DATA-TRANSFER MODE
Windows 98 and 98 Second Edition
1. Turn off the camera.
2. Change the memory card.
3. Turn on the camera to remake the USB connection.
Windows ME, 2000 Professional, and XP
Macintosh
1. Stop the USB connection using the unplug-or-eject-hardware routine (p. 96).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
1. Stop the USB connection by dragging the drive icon into the trash (p. 97).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
Never remove the card when the indicator lamp is red and blinking - the
data or memory card may permanently be damaged.
To Next Page
Loading...
Need help?
General
