ASPEN-32UFX, ASPEN-1616UX, VS-8UFX – Connecting ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
Always switch off the power to each device before connecting it to your ASPEN-32UFX,
ASPEN-1616UX, VS-8UFX. After connecting your ASPEN-32UFX, ASPEN-1616UX,
VS-8UFX, connect its power and then switch on the power to each device.
For illustrative purposes, the figure below shows ASPEN 32UFX, but the same connections
apply to ASPEN 1616UX. The only exception is that for ASPEN 32UFX the sources and
acceptors can be connected to any of the 32 interchangeable ports and for ASPEN 1616UX
the sources must be connected to the inputs and the acceptors to the outputs.
Figure 5: Connecting to the ASPEN-32UFX Rear Panel
To connect ASPEN 32UFX or ASPEN 1616UX as illustrated in Figure 5:
1. Connect the video sources (for example, SDI camera, FC-113 HDMI
TM
-SDI Converter)
and acceptors (for example, SDI display, VP-475UX SDI to HDMI converter):
▪ For ASPEN-32UFX connect up to 32 video sources and acceptors to the
interchangeable PORT BNC Connectors .
▪ For ASPEN 1616UX connect up to 16 video sources to the INPUT BNC
Connectors and up to 16 video acceptors to the OUTPUT BNC Connectors .
2. Connect the LAN to the ETHERNET RJ-45 Connector .
3. Connect a control device (for example, computer or serial controller) to the RS-232
Terminal Block Connector .
4. If required, connect a genlock source to the GENLOCK BNC Connector .
To Next Page
Loading...
Need help?
General
