ASPEN-32UFX, ASPEN-1616UX, VS-8UFX – Defining ASPEN-32UFX, ASPEN-1616UX, VS-8UFX 12G SDI
Matrix Switcher
Figure 3: VS-8UFX 12G SDI Matrix Switcher Front Panel
Lights when the device is powered.
Press an output port (lit green) and then an input port (lit blue) to
route an input to an output.
Press to clear a selection.
Press to enter Take mode.
In Take mode, press several sets of output-input ports and then
press TAKE to activate all the selected routings at the same time.
When Take mode is off, each output-input pair is switched
immediately.
To load a preset configuration:
Press LOAD, press the appropriate PORT preset button to select
a preset configuration, and then press TAKE to load that preset.
To save the current port configuration to a PORT preset button:
Press SAVE, press the port button to which you want to save the
configuration, and then press TAKE to save the setup to that port.
Press to display general information, such as the firmware version
and IP address.
Press INFO and then a specific PORT button to display the
information of that selected port.
Displays the current routing status, device information and so on.
Press for 3 seconds (approx.) to lock the front panel buttons.
When locked (button is lit), press again for 3 seconds (approx.) to
unlock the front panel buttons.
Figure 4: VS-8UFX 12G SDI Matrix Switcher Back Panel
Connect a the genlock source.
Connect to the genlock connector of the next unit in the daisy
chain or terminate with 75Ω.
PORTS BNC Connectors (1 to 8)
Connect to SDI sources and acceptors.
RS-232 (G,Rx,Tx) Terminal Block
Connector
Connect to a PC or remote controller.
Connect to a PC via LAN for unit control and firmware upgrade
via the web pages.
To Next Page
Loading...
Need help?
General
