3 Overview
The TP-582T and TP-582R are a high-quality twisted pair transmitter and
receiver for HDMI, 100BaseT Ethernet, bidirectional RS-232 and IR
signals.
With the TP-582T you can select one of two HDMI inputs, and convert it
with the 100BaseT Ethernet, RS-232 and IR input signals to a twisted pair
signal. The TP-582R converts the twisted pair signal back to 100BaseT
Ethernet, RS-232, IR and two HDMI outputs, and de-embeds the audio to
S/PDIF and TOSLINK® audio outputs. The TP-581T is identical to the
TP-582T but has only one HDMI input
.
For optimum range and performance using HDBaseT™, use Kramer's BC−HDKat6a
cable. Note that the transmission range depends on the signal resolution, source and
display used. The distance using non−Kramer CAT 6 cable may not reach these ranges.
3.1 Features of the TP-581T, TP-582T and TP-582R
This transmitter/receiver pair features:
Signals of up to 6.75Gbps (up to 1080p@60Hz 36 bit) over a range of up
to 130m (430ft) when using BC−HDKat6a cables
HDTV compatibility
HDMI support (V.1.4 with Deep Color, x.v.Color™, Lip Sync, HDMI
Uncompressed Audio Channels, Dolby TrueHD, DTS-HD, CEC)
3D pass through
HDCP compliance
EDID PassThru, passes EDID/HDCP signals from source to display
A bidirectional RS-232 interface over which commands and data can
flow in both directions via the RS-232 interface at rates up to 115200,
allowing status requests and control of the destination unit
Bidirectional infrared interface for remote control of peripheral devices
(see Section 5.3)
100BaseT Ethernet interface for connection to a network (see Section 3.2)
LED status indicators for input, output, link and power
Two RJ-45 CAT 5 output connectors: one for the line output and the
other for the Ethernet input
Since the TP-581T has only one input, it does not have the input selection control which the TP-582T has (that is, contact
closure, IR and front panel input selection)
To Next Page
Loading...
Need help?
General
