Safety
23
Pos: 42.16 /BA/Sic herheit/Wartu ng/Wartung S wadro @ 2\m od_12035040 22126_78.doc @ 66245
4.11 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When performing maintenance work with the machine raised, always secure it with
suitable supporting elements!
4 Oils, greases and filters must be disposed of correctly!
5 Always disconnect the power supply before working on the electrical system!
6 If protective devices and guards are subject to wear, check them regularly and replace
them in good time!
7 When performing electrical welding work on the vehicle and mounted devices, turn power
supply off at main battery switch or disconnect generator cable and battery!
8 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
Pos: 42.17 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165
To Next Page
Loading...
Need help?
General
