KTM 250 EXC 2023 User Manual

12 SERVICE WORK ON THE CHASSIS
96
S04882-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 ( p. 168)
– On the clutch slave cylinder, remove bleeder protection cap,
release the bleeder screw
5
and mount bleeding syringe
4
.
E01224-10
–
Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Tighten the bleeder screw.
Mount protection cap.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.45 Removing the engine guard (All special models)
H01638-10
–
Remove screws
1
and engine guard.
12.46 Installing the engine guard (All special models)
H01638-10
– Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)

KTM 250 EXC 2023 Specifications

General

Brand	KTM
Model	250 EXC 2023
Category	Motorcycle
Language	English