8 RIDING INSTRUCTIONS 23
401944-10
(XC‑F US)
–
Take the motorcycle off side stand
1
and secure the side stand with rubber
band
2
.
– Shift the transmission to idle.
Condition
Ambient temperature: < 20 °C (< 68 °F)
– Push the cold start button in all the way.
400733-01
– Press the electric starter button .
Info
Press the electric starter button for a maximum of 5 seconds. Wait for 30
seconds before a further attempt at starting.
At temperatures below 15 °C (60 °F), several attempts at starting may be
necessary to warm-up the lithium-ion battery and thereby increase the start-
ing power.
During the starting process, the malfunction indicator lamp lights up.
8.3 Activating Launch Control
Info
The Launch Control assists the rider to optimally accelerate the motorcycle at the beginning of a race. The maximum speed of
the engine with the throttle valve fully opened (full throttle) is reduced. After the start, it is gradually increased up to the max-
imum engine speed. The rider opens the throttle fully throughout this procedure. The clutch must be activated exactly as it
would be without an active Launch Control.
Condition
The motorcycle is stationary.
The engine is running at idle speed.
The transmission is in neutral.
H01179-10
– Press and hold MAP and TC buttons simultaneously.
Malfunction indicator lamp flashes orange rapidly.
Info
Several seconds after the vehicle starts, Launch Control is deactivated auto-
matically.
The Launch Control is also deactivated in the following cases (malfunction
indicator lamp no longer flashes): After full throttle, the throttle valve was
closed by more than 1/3 of the way and/or there is no start within 3 min-
utes.
To reactivate Launch Control, the engine must first be switched off for at
least 10 seconds for safety reasons. This must occur regardless of whether
the engine was started or not.
8.4 Activating traction control
Info
The traction control reduces excessive slip on the rear wheel in favor of more control and propulsion, particularly in wet condi-
tions.
When traction control is switched off, the rear wheel may spin more during high acceleration and on surfaces with low grip.
Traction control can be switched on or off during the ride.
The setting most recently selected is activated again when restarting.
To Next Page
Loading...
Need help?
General
