10 TUNING THE CHASSIS 37
10.14 Adjusting the compression damping of the fork
Info
The hydraulic compression damping determines the fork suspension behavior.
S01205-10
–
Turn adjusting screw
1
clockwise all the way.
Info
Adjusting screw
1
is located at the upper end of the right fork leg.
– Turn counterclockwise by the number of clicks corresponding to the fork type.
Guideline
Compression damping (SX‑F EU)
Comfort 15 clicks
Standard 12 clicks
Sport 9 clicks
Compression damping (SX‑F US)
Comfort 20 clicks
Standard 17 clicks
Sport 12 clicks
Compression damping (XC‑F US)
Comfort 15 clicks
Standard 12 clicks
Sport 10 clicks
Compression damping (SX‑F Factory Edition)
Comfort 17 clicks
Standard 12 clicks
Sport 7 clicks
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
10.15 Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
M01100-10
–
Remove protection cap
1
.
–
Turn adjusting screw
2
clockwise all the way.
Info
Adjusting screw
2
is located at the lower end of the right fork leg.
– Turn counterclockwise by the number of clicks corresponding to the fork type.
To Next Page
Loading...
Need help?
General
