SETUP 2
3
2.1 Transport mode
H02712-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Diagnostics connector
F03736-10
Diagnostics connector
1
is located under the seat.
Info
As soon as the diagnostics tool is connected, the service
hourmeter starts running.
Before longer diagnostic sessions, unplug the service
hourmeter behind the start number plate.
2.3 Unpacking and setting up the vehicle
F01082-01
– Remove the box and the plastic packaging.
Guideline
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle until
work has been completed.
– Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
– Have a lift stand available.
Lift stand (78129955100)
F03419-10
–
Carefully loosen and remove tension belt
1
from the footrest
brackets on the left and right.
Info
An assistant prevents the motorcycle from falling over.
–
Remove screws
2
from the footrest bracket on the left and
right.
To Next Page
Loading...
Need help?
General
