KTM 50 SX 2015 User Manual

11 MAINTENANCE WORK ON THE CHASSIS 29
601594-10
– Loosen screws 3. Remove the left fork leg.
– Loosen screws 4. Remove the right fork leg.
11.7 Installing the fork legs x
601595-10
Main work
– Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws 1 to the front.
601594-11
– Tighten screws 2.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
– Tighten screws 3.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
601593-11
– Position brake caliper, mount, and tighten screws 4.
Guideline
Screw, front brake caliper M8 20 Nm
(14.8 lbf ft)
Loctite
®
243™
– Position the brake line. Put the clamp on, and mount and tighten screws 5.
Finishing work
–
Install the front wheel. x ( p. 55)
11.8 Removing the lower triple clamp x
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 27)
–
Remove the front wheel. x ( p. 55)
–
Remove the fork legs. x ( p. 28)
– Dismount the start number plate. ( p. 33)
– Dismount the front fender. ( p. 33)
601604-10
Main work
– Remove fuel tank breather 1.
– Loosen screw 2. Remove nut 3, take off the top triple clamp with the handlebar,
and place it on one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.

KTM 50 SX 2015 Specifications

General

Brand	KTM
Model	50 SX 2015
Category	Motorcycle
Language	English