KTM 50 SX 2017 User Manual

11 SERVICE WORK ON THE CHASSIS 37
V00269-11
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
–
Tighten screws

.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
H01183-11
(50 SX Mini)
– Position the fork legs.
Bleeder screws

are positioned toward the front.
Info
The second milled groove in the fork leg must be flush with the upper
edge of the upper triple clamp.
V00268-11
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
–
Tighten screws

.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
V00271-10
–
Position the brake caliper, and mount and tighten screws

.
Guideline
Screw, front brake caliper M8 20 Nm
(14.8 lbf ft)
Loctite
®
243™
–
Position the brake line and clamp. Mount and tighten screws

.
Finishing work
– Install the front wheel. ( p. 67)
11.9 Removing the lower triple clamp
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 34)
– Remove the front wheel. ( p. 67)
– Remove the fork legs. ( p. 36)
– Remove the start number plate. ( p. 43)
– Dismount the front fender. ( p. 44)
V00272-10
Main work
–
Pull fuel tank breather

out of the steering stem.
–
Loosen screw

. Remove nut

, take off the upper triple clamp with the handle-
bar, and place it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.

KTM 50 SX 2017 Specifications

General

Brand	KTM
Model	50 SX 2017
Category	Motorcycle
Language	English