14 WHEELS, TIRES 124
Warning
Danger of accidents No braking effect when operating the rear brake.
– After installing the rear wheel, always operate the foot brake until the pressure point is reached.
Main work
(RC 200)
– Check the rear hub rubber dampers. ( p. 127)
L02199-11
–
Remove spacers
.
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change the rear wheel bearing.
–
Clean and grease the shaft seal rings
and mating surfaces
of the spacers.
Long-life grease ( p. 198)
– Insert the spacers.
–
Clean the thread of the wheel spindle and nut
.
– Clean the mating surfaces of the brake caliper support and swingarm.
– Position the rear wheel.
The brake linings are correctly positioned.
– Push the rear wheel as far forward as possible and place the chain on the rear
sprocket.
To Next Page
Loading...
Need help?
General
