15 ELECTRICAL SYSTEM 143
15.7 Changing the high beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
L02162-10
Main work
–
Turn socket
counterclockwise.
–
Pull the socket with high beam bulb
out of the headlight housing.
–
Disconnect the socket with the high beam bulb from connector
and remove.
– Connect the new socket with the high beam bulb to the connector.
High beam (H9/socket PGJ19-5) ( p. 188)
To Next Page
Loading...
Need help?
General
