16 COOLING SYSTEM 153
16.5 Draining the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water immedi-
ately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If fuel is swallowed, con-
tact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of children.
Condition
The engine is cold.
Preparatory work
– Remove the right side cover. ( p. 103)
– Remove the left side cover. ( p. 100)
– Remove the front spoiler. ( p. 96)
L02173-10
Main work
– Position the motorcycle upright.
– Place a suitable container under the engine.
–
Remove screw
.
– Remove the radiator cap.
– Completely drain the coolant.
–
Mount and tighten screw
with a new seal ring.
To Next Page
Loading...
Need help?
General
