To Next Page

To Previous Page

22 BLINK CODE 174

Blink code engine diagnostic

warning lamp (MIL)

02 Engine diagnostic warning lamp (MIL) flashes 2x short

Error level condition Crankshaft position sensor - measurement range or power problem

Blink code engine diagnostic

warning lamp (MIL)

06 Engine diagnostic warning lamp (MIL) flashes 6x short

Error level condition Throttle position sensor circuit A - input signal too low

Throttle position sensor circuit A - input signal too high

Blink code engine diagnostic

warning lamp (MIL)

09 Engine diagnostic warning lamp (MIL) flashes 9x short

Error level condition Manifold absolute pressure sensor - input signal too low

Manifold absolute pressure sensor - input signal too high

Blink code engine diagnostic

warning lamp (MIL)

11 Engine diagnostic warning lamp (MIL) flashes 1x long, 1x short

Error level condition Idle control - engine speed below target value

Idle control - engine speed above target value

Blink code engine diagnostic

warning lamp (MIL)

12 Engine diagnostic warning lamp (MIL) flashes 1x long, 2x short

Error level condition Engine coolant temperature sensor - input signal too low

Engine coolant temperature sensor - input signal too high

Questions and Answers:

Need help?

Do you have a question about the KTM RC 200 and is the answer not in the manual?

KTM RC 200 Specifications

General

Displacement	199.5 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Rear Suspension	WP APEX Monoshock
Bore x Stroke	72 mm x 49 mm
Compression Ratio	11.5:1
Max Power	25 PS @ 10000 rpm
Max Torque	19.2 Nm @ 8000 rpm
Front Brake	300 mm disc
Rear Brake	230 mm disc
Fuel Tank Capacity	13.7 liters
Kerb Weight	160 kg
Front Suspension	WP APEX 43 mm Upside Down
ABS	Dual Channel
Tyre Front	110/70-17
Tyre Rear	150/60-R17
Ground Clearance	157 mm
Engine Type	Single Cylinder, Liquid Cooled