EasyManuals Logo
Home>Kubota>Cutter>AP-SC7072

Kubota AP-SC7072 User Manual

Kubota AP-SC7072
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Section 1: Assembly & Set-up
Table of Contents
AP-SC7072 Skid Cutter 326-974MK 2/6/19
8
Hitch Hook-Up
Refer to Figure 1-1:
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate lift and/or tilt controls while
someone is near the power machine and/or attachment.
1. Make sure hydraulic hoses and height adjustment
safety chain do not interfere with hitch hook-up.
2. Drive skid steer slowly to the Skid Cutter making sure
the front hitch plate of the skid steer is parallel with
the Skid Cutter hitch.
3. Tilt top of skid steer hitch plate slightly forward.
4. Place top of skid steer hitch plate directly under the
Skid Cutter top angle bar.
5. Slowly lift skid steer hitch until it fully contacts the
Skid Cutter top angle bar.
6. Slowly rotate skid steer hitch plate back.
7. Engage skid steer lock handles. Make sure the pins
go through the bottom slots of the Skid Cutter’s hitch
and the handles lock down.
NOTE: If the skid steer is not equipped with
hydraulic lock handles, the skid steer must be shut
down and lock handles must be manually engaged.
Refer to “Skid Steer Shutdown Procedures” on
page 16.
Skid Steer Hook-Up
Figure 1-1
70405
Top Angle Bar
Bottom Slots
Height Adjustment Safety Chain (Chain must run under the upper
cross tube and skid steer hitch plate then attach to Skid Steers
lower hitch loop). See Figure 1-2.
Female Coupler
Male Coupler
Blade Bolt Access Hole
Zip tie hydraulic hoses together.
Upper Cross Tube
Hose ring
Refer to Figure 1-2
8. Connect the safety chain to the skid steer. For
additional information on how to adjust the safety
chain, see “Height Adjustment Safety Chainon
page 9.
Height Adjustment Safety Chain (Kubota SVL Shown)
Figure 1-2
70031
Upper cross tube
Skid steer hitch plate
Safety chain stud
IMPORTANT: The safety chain must run under the
upper cross tube and the skid steer hitch plate or
damage can occur.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota AP-SC7072 and is the answer not in the manual?

Kubota AP-SC7072 Specifications

General IconGeneral
BrandKubota
ModelAP-SC7072
CategoryCutter
LanguageEnglish

Related product manuals