Section 1: Assembly & Set-up
Table of Contents
AP-SC7072 Skid Cutter 326-974MK2/6/19
11
Case Drain Assembly
Figure 1-6
70406
Case Drain Assembly (Optional)
Refer to Figure 1-6:
1. Ensure the Cutter is parked on a flat level surface,
and if the cutter is attached to a skid steer, follow
proper shut down procedures. See “Skid Steer
Shutdown Procedures” on page 16.
2. Loosen six 3/8"-16 hex nuts (#2). Removing the hex
nuts is not necessary.
3. Remove the motor shroud (#1) by pushing it toward
the front of the unit then lifting it upward.
4. Remove plug from port (C) in hydraulic motor (#4).
5. Attach adapter fitting (#3) to port (C) in hydraulic
motor (#4) as shown and tighten to correct torque.
6. Route hydraulic hose (#5) through designated areas
(A & B) as shown.
7. Attach female end of hydraulic hose (#5) to adapter
fitting (#3) and tighten.
8. Place the motor shroud back in its designated place
and pull back to lock it in place. Tighten hex nuts (#2)
to correct torque.
9. Attach flat faced coupler (#6) to the male end of
hydraulic hose (#5) and tighten.
10. Connect coupler (#6) to case drain reservoir on skid
steer.
11. Zip tie the case drain hydraulic hose to the two
existing hoses.Pressure Gauge Assembly (Optional)
WARNING
!
To avoid serious injury or death:
Cutter deck can be slippery when wet. Always step on grip
pads when possible. Never hurry. Make sure you have secure
footing and hand hold when walking on the deck.
To Next Page
Loading...
Need help?
General
