PERIODIC SERVICE64
7. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
8. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
BAdjusting Front Axle Pivot [4WD]
To avoid personal injury or death:
A Park the tractor on a flat place.
A Lower the implement, lock the parking brake
and stop the engine.
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, and tighten the adjusting screw so
that the oscillating load is 50 to 100 N (5.1 to 10.2 kgf, 11.2
to 22.5 lbf). (If the adjusting screw is tightened, loosened
and retightened, apply liquid gasket to its tip.) Retighten
the lock nut.
Consult your local KUBOTA Dealer for further details.
BReplacing Fuel Filter Element
(See "Cleaning Fuel Filter" in "EVERY 100 HOURS" in
"PERIODIC SERVICE" section.)
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Adjusting screw
(2) Lock nut
To Next Page
Loading...
Need help?
General
