PERIODIC SERVICE OF THE TRACTOR70
BCleaning Panel and Radiator Screen
To avoid personal injury:
A Be sure to stop the engine and remove the key
before removing the screen.
1. Check panel screen to be sure they are clean from
debris.
2. Detach the radiator screen, and then remove all the
foreign material.
A If the dust or chaff is accumulated in the battery
compartment, open the panel and clean completely.
A Panel and radiator screen must be clean from debris
to prevent engine from overheating and to allow good
air intake for air cleaner.
A Be sure to reinstall the panel on the pillar completely
to prevent the invasion of dust.
A Be sure to stop the engine to avoid personal injury and
to allow good air intake for air cleaner.
BChecking Brake Pedal
1. Inspect the brake pedal for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Brake Pedal" in every 100 hours
maintenance.)
BChecking Gauges, Meters and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM) lamps.
2. Replace if broken.
BChecking Head Light, Hazard Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking and Cleaning of Electrical
Wiring and Battery Cables
To avoid personal injury:
A A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage
of electricity could result in a fire hazard, a
dead battery or damage to electrical
components.
A Replace damaged wires or connections
promptly.
A If a fuse blows soon after replacement, DO NOT
USE A LARGER THAN RECOMMENDED FUSE
OR BYPASS THE FUSE SYSTEM.
A Many wiring connections are protected by
waterproof plugs, plug and unplug these
connections carefully and make sure they are
sealed correctly after assembly.
A Accumulation of dust, chaff or spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system are a fire hazard.
CLEAN THESE AREAS BEFORE STARTING
WORK.
To avoid premature electrical malfunctions DO
NOT APPLY high pressure water directly to
battery, wiring, connectors, electrical
components or instrument panel.
(1) Panel
(2) Knob
(3) Center pillar
(A) "DETACH"
(1) Radiator screen (A) "DETACH"
To Next Page
Need help?
General
