22 PRE-OPERATION CHECK OF THE BACKHOE
PRE-OPERATION CHECK OF THE BACKHOE
PRE-OPERATION CHECKS
Prior to starting the engine, make pre-operation checks
according to "MAINTENANCE OF THE BACKHOE"
section.
To avoid personal injury:
A Read " SAFE OPERATION " section in the front
of this manual.
A Read the warning and caution labels located on
the backhoe.
A Make sure the swing lock pin is set before
entering or exiting the backhoe operator area.
OPERATOR'S SEAT
Operator's seat for the BX25DLB tractor can be used to
operate loader and backhoe. See "OPERATING THE
TRACTOR" section for the detail to turn the seat around
for backhoe operation. When operating backhoe, the seat
belt should be used.
BSeat Belt
To avoid personal injury:
A Always use the seat belt when the ROPS is
installed.
Do not use the seat belt if a foldable ROPS is
down or there is no ROPS.
Adjust the seat belt for proper fit and connect to the
buckle. The seat belt is auto-locking retractable type.
BALLAST
To avoid serious personal injury or death:
A Never remove loader to ensure tractor stability
at all times.
A Do not add liquid ballast or any other weights to the
front tires.
A While BT602 backhoe is installed on the tractor, liquid
ballast in the rear tires should be removed.
TIRE INFLATION
Insure that the tractor tires are properly inflated.
See "TIRES, WHEELS AND BALLAST" section.
PRE-OPERATING INSTRUCTION
(1) Operator's seat (backhoe position)
To Next Page
Loading...
Need help?
General
