57OPERATING THE LOADER
OPERATING THE LOADER
The loader should be operated with the tractor engine
speed depending on the application and the operator's
level of experience. Excessive speeds are dangerous,
and may cause bucket spillage and unnecessary strain on
the tractor and loader.
When operating in temperatures below -1 C(30 F), run
the tractor engine below 1200 rpm until the oil
temperature exceeds -1 C(30 F).
The following text and illustrations offer suggested loader
and tractor operating techniques.
To reduce the possibility of roll over:
A It is not recommended that the loader be attached
when operating another implement on a hillside.
A When operating the loader in rough terrain, remove
the mower to avoid damage to the mower.
FILLING THE BUCKET
Approach and enter the pile with a level bucket.
Ease control lever toward you and then left to rollback and
lift the bucket.
The rollback and lifting of the bucket will increase
efficiency because a level bucket throughout the lifting
cycle resists bucket lift and increases breakaway effort.
A Do not be concerned if the bucket is not completely
filled during each pass. Maximum productivity is
determined by the amount of material loaded in a
given period of time. Time is lost if 2 or more attempts
are made to fill the bucket on each pass.
LIFTING THE LOAD
When lifting the load, keep the bucket positioned to avoid
spillage.
To avoid serious personal injury:
A Do not attempt to lift bucket loads in excess of the
loader capacity.
A Before raising the bucket to full height, make sure
the tractor is on level ground. If not, it may tip over,
even if the tractor is not moving.
To Next Page
Loading...
Need help?
General
