PERIODIC SERVICE54
EVERY 50 HOURS
BLubricating Grease Fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
BChecking Engine Start System
To avoid personal injury:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test, do not
operate the tractor.
C Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range gear shift lever to "NEUTRAL" position.
4. Check the speed control pedal "NEUTRAL" position.
5. Shift the PTO clutch lever to "OFF" position.
C Test 1: Switch for the speed control pedal
1. Make sure that the range gear shift lever is set in
"NEUTRAL" position.
2. Depress the speed control pedal.
3. Turn the key to "START" position.
4. The engine must not crank.
5. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test 2: Switch for the PTO clutch lever
1. Make sure that the range gear shift lever is set in
"NEUTRAL" position.
2. Make sure that the speed control pedal is set in
"NEUTRAL" position.
3. Shift the PTO clutch lever to "ON" position.
4. Turn the key to "START" position.
5. The engine must not crank.
6. If it cranks, consult your local KUBOTA Dealer for this
service.
(1) Grease fitting (Speed control pedal)
(1) Battery terminals
(1) Range gear shift lever (Hi-Lo)
(2) PTO clutch lever
(3) Speed control pedal
To Next Page
Loading...
Need help?
General
