EasyManuals Logo
Home>Kubota>Tractor>BX2670

Kubota BX2670 User Manual

Kubota BX2670
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
PERIODIC SERVICE60
3. Extend the turnbuckle one additional turn.
4. Retighten the lock nut.
5. Depress the brake pedal several times and make sure
the brake pedal free travel is from 25 to 35 mm (1.0 to
1.4 in.)
EVERY 200 HOURS
BReplacing Engine Oil Filter
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
5. Properly dispose of used oil.
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1) Lock nut
(2) Turnbuckle
(A) Free travel
(B) Right rear tire
(1) Engine oil filter

Table of Contents

Other manuals for Kubota BX2670

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota BX2670 and is the answer not in the manual?

Kubota BX2670 Specifications

General IconGeneral
BrandKubota
ModelBX2670
CategoryTractor
LanguageEnglish

Related product manuals