S.G
GENERAL
92.4mm
STROKE
SERIES
WSM,
0109A
171
CHECK
AND
MAINTENANCE
H
NOTE
0
Some types of gearcases are provided with an oil
filler
port. When the cylinder head has been
reassembled or when the valve clearance
has
been readjusted, apply an enough amount of
oil
to
the
intake and exhaust valves, push rod and rocker arm just before fitting the head cover in position.
(1)
Daily
Check
Points
4
01766
Checking Engine Oil Level
1.
Level the engine.
2.
To
check the oil level, draw out the dipstick
(l),
wipe
it
clean, reinsert
it,
and draw
it
out again.
Check to
see
that the oil level
lies
between
the
two
notches.
3.
If
the level
is
too low, add new
oil
to the specified
level.
H
IMPORTANT
When using an oil of different maker or viscosity
from the previous one, drain old oil. Never mix
two differenttypes of oil.
(1)
dipstick
Checking and Replenish Cooling Water
1.
Remove the radiator cap and check
to
see
that
the
2.
-If
low, add clean water and antifreeze.
cooling water level
is
just bellow the port.
0
Do
not remove the radiator cap
until
cooling
water temperature
is
below
its
boiling point.
Then loosen the cap slightly
to relieve any excess
pressure before removing
the
cap completely.
H
IMPORTANT
0
Be sure to close the radiator cap securely.
If
the
cap
is
loose
or
improperly closed, water may leak
out and the engine could overheat.
0
Do
not use an antifreeze and
scale
inhibitor
at
the
same time.
s-35
To Next Page
Loading...
Need help?
General
