5.5
ELECTRICAL SYSTEM
92.4mm STROKESERIES WSM.0109A
I
3309F092
H
ELECTRICAL SYSTEM
GIOW
plug
resistance
CHECKING
[I]
STARTER
s',"zrY
0.8
il
01850F10430
\t
[Z]
GLOW PLUG
I0011F177
I
Motor Test
1.
Disconnect the connecting lead from the
"C"
terminal of the starter and connect
a
jumper lead
from the connecting lead to the positive battery
terminal.
2.
Connect
a
jumper lead momentarily between the
starter body and the negative battery terminal,
3.
If
the motor does not run, check
the
motor.
Magnet
Switch
1.
Disconnect the connecting lead from
the
"C"
terminal
of
the starter.
2. Connect jumper leads from
the
negative terminal
of
6
V
battery to the body and
"C"
terminal
of
the
magnet switch.
3.
The pinion gear should pop out, when a jumper
lead
is
connected between the positive terminal of
the battery to the
"S"
terminal
of
the magnet
switch.
4.
The pinion gear should stay out without the
jumper from
the
negative terminal to
the
"C"
terminal,
NOTE
about
3
to
5
seconds.
0
Each
test should be carried out
for
a short time,
s-I
11
To Next Page
Loading...
Need help?
General
