OPERATING THE ENGINE12
BKey Switch
[GR2020G]
A Do not use starting fluid or ether.
A To protect the battery and the starter, make sure that
the starter is not continuously turned for more than 10
seconds at a time.
If the engine does not start, allow 60-second cool
down period between starting attempts.
A If the starter does not turn the engine over, shut off the
starter immediately. Do not make further attempts to
start the engine until the condition is corrected. Do not
jump start using another battery.
Consult your local KUBOTA dealer.
A Do not turn the key switch to the "START" position
while the engine is running.
A When the temperature is below 0 (32 ), run the
engine at medium speed to warm up the lubricant of
the engine and the transmission for at least 10
minutes. If the machine is operated before the
lubricant is warm enough, the machine life will be
shortened.
A Do not operate the machine under full load until it is
sufficiently warmed up 2 or 3 minutes for temperature
above 0 (32 ).
A When the ambient temperature is less than -15
(5 ), remove the battery from the machine and store
it somewhere warm until the next operation.
4. Set the throttle lever 1/2 way forward.
(1) Throttle lever : "FAST"
: "SLOW"
5. Insert the key into the key switch and
turn clockwise 1 notch.
Make sure the easy checker lights are
ON.
OFF............ The position where the key can be
inserted into or removed from the
key switch. [When the key is turned
to this position, the engine shuts off.]
ON..............
The engine keeps running.
START........ Apply the parking brake and turn the
key switch to this position to start the
engine.
: "OFF"
: "ON"
: "START"
To Next Page
Loading...
Need help?
General
