EasyManua.ls Logo

Kubota GR2120AU - Replacing Fuel Filter; Every 1500 Hours; Checking Fuel Injection Nozzle (Injection Pressure); Every 3000 Hours

Kubota GR2120AU
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71PERIODIC SERVICE
BReplacing Fuel Filter
[GR2120, GR2120AU]
Change fuel filter every 400 hours. Consult your local
KUBOTA Dealer for this service.
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle (Injection
Pressure)
[GR2120, GR2120AU]
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
BChecking Injection Pump
[GR2120, GR2120AU]
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR
BReplacing Air Cleaner Element
[GR2120, GR2120AU]
Change the element once a year.
BFlush Cooling System and Changing
Coolant
[GR2120, GR2120AU]
To avoid serious injury:
A Do not remove the radiator cap when the
engine is hot. Then loosen cap slightly to the
stop to relieve any excess pressure before
removing cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, remove the radiator drain plug
and the engine drain plug, and remove the radiator
cap. The radiator cap must be removed to completely
drain the coolant.
3. After all coolant is drained, install the drain plugs.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the fill port on the
radiator.
Install the radiator cap securely.
7. Fill with coolant up to "FULL" on the recovery tank.
8. Start and operate the engine for a few minutes.
9. Stop the engine and let cool.
10.Check coolant level of recovery tank and add coolant
if necessary.
(1) Radiator drain plug
(1) Engine drain plug

Table of Contents

Related product manuals