Kubota L3560 User Manual

PERIODIC SERVICE104
A Use DPF-compatible oil (CJ-4) for the engine.
BReplacing Engine Oil Filter
To avoid personal injury or death:
A Be sure to stop the engine before replacing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
BChanging Transmission Fluid / Replacing
Hydraulic Oil Filter
C Cleaning Magnetic Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Drain plug
(1) Drain plug
(1) Engine oil filter

Kubota L3560 Specifications

General

Brand	Kubota
Model	L3560
Category	Tractor
Language	English