7SPECIFICATIONS
SPECIFICATION TABLE [Manual Transmission Type]
Model
L3560 L4060
4WD
Engine
Model D1803-CR-E4 V2403-CR-E4
Type Direct injection vertical, water-cooled, 4-cycle diesel
Number of cylinders 3 4
Total displacement L (cu. in.) 1.826 (111.4) 2.434 (148.5)
Bore and stroke mm (in.) 87 x 102.4 (3.4 x 4.0)
Rated revolution rpm 2700
Low idling revolution rpm 800
Net power* kW (HP) 26.1 (35.0) 29.8 (40.0)
PTO power*
(factory observed)
kW (HP)/rpm 22.0 (29.5) / 2700 25.4 (34.0) / 2700
Maximum torque N-m (ft-lbs.) 114.1 (84.2) 133.5 (98.5)
Battery capacity 12V, RC: 133 min, CCA: 582A
Capacities
Fuel tank L (U.S.gals.) 51 (13.5)
Engine crankcase (with filter) L (U.S.qts.) 6.7 (7.1) 8.2 (8.7)
Engine coolant L (U.S.qts.) 7.5 (7.9)
Transmission case L (U.S.gals.) 42 (11.1) 43 (11.4)
Dimensions
Overall length (without 3p) mm (in.) 2920 (115.0) 3085 (121.5)
Overall width (min. tread) mm (in.) 1520 (59.8) 1690 (66.5)
Overall height (with ROPS) mm (in.) 2470 (97.2) 2480 (97.6)
Wheel base mm (in.) 1805 (71.1) 1895 (74.6)
Min. ground clearance mm (in.) 342 (13.5) 360 (14.2)
Tread
Front mm (in.) 1155 (45.5)
Rear mm (in.)
1200 (47.2), 1300 (51.2),
1385 (54.5), 1480 (58.3)
1285 (50.6), 1435 (56.5), 1530 (60.2)
Weight (with ROPS) kg (lbs.) 1590 (3505) 1635 (3605)
Traveling
system
Standard
tire size
Front 7-16 8.3-16
Rear 12.4-24 14.9-24
Clutch Dry type single stage
Steering Hydrostatic power steering
Transmission 8 forward and 8 reverse fully synchronized main and shuttle transmission
Braking system Wet disk type
Min. turning radius
(with brake)
m (feet) 2.7 (8.9)
Hydraulic
unit
Hydraulic control system Position control
Pump capacity
L (U.S.gals)/
min.
31.5 (8.3) 37.0 (9.8)
3-point hitch SAE category 1
Max. lift force
At lift points kg (lbs.) 1700 (3750) 1750 (3860)
24 in.
behind lift
points
kg (lbs.) 1200 (2650) 1250 (2760)
System pressure MPa (kgf/cm ) 17.7 (180)