Kubota M6060 User Manual

PERIODIC SERVICE102
BLubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
EVERY 500 HOURS
BChanging Engine Oil
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
A Use DPF-compatible oil (CJ-4) for the engine.
(1) Front wheel hub cover
Oil capacity with filter 12 L (12.7 U.S.qts.)
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range
(1) Drain plug

Kubota M6060 Specifications

General

Engine Type	Diesel
Cylinders	4
Fuel Type	Diesel
Hydraulic System	Open center
Lift Capacity	3, 307 lbs
Transmission	8F / 8R
Fuel Tank Capacity	17.7 gal
Displacement	148.5 cubic inches
3-Point Hitch	Category I/II
Horsepower	63.4 HP