OPERATING THE ENGINE22
C Check Easy Checker(TM) Indicators:
1. When the key is turned "ON", indicators (2) (3) should
come on. If trouble should occur at any location while
the engine is running, the indicator corresponding to
problem will turn "ON".
2. Suppose that the engine coolant temperature is not
high enough yet. The heater indicator (4) also turns
"ON" when the key is turned "ON" to preheat the
engine and goes off automatically when preheat is
completed.
Illumination time of indicator varies according to the
temperature of coolant.
3. The PTO clutch indicator (1) comes on while PTO
clutch control switch is engaged "ON" and goes off
when disengaged.
4. If the fuel level indicator (5) lights up, when fuel level is
very low, therefore add fuel and the indicator will turn
"OFF".
5. If the parking brake warning indicator (6) does not
illuminate, set the parking brake.
A Some of the Easy Checker(TM) indicators may
illuminate or start flashing depending on the positions
of the levers and switches.
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to Daily Check. (See "DAILY CHECK" in
"PERIODIC SERVICE" section.)
A Because of the safety devices, the engine will not start
except when the PTO clutch control switch is placed in
the "OFF" position and shuttle shift lever is placed in
the "NEUTRAL" position.
If an indicator is still on, immediately stop the engine and
determine the cause.
6. Insert the key into the key switch and
turn it "ON".
"OFF" (Engine-Stop)
"ACC" (Electrical
Power-accessories)
"ON" (Engine-Run)
"START" (Engine-Start)
NOTE:
ACC... A The accessories can be used while the
engine is stopped.
A Do not leave the key at "ACC" position. The
battery will be quickly discharged. Turn it
back to "OFF" after use.
(1) PTO clutch indicator
(2) Electrical charge warning
indicator
(3) Engine oil pressure warning
indicator
(4) Heater indicator
(5) Fuel level indicator
(6) Parking brake warning
indicator
(7) Key switch
7. Fully depress the clutch pedal.
8. Turn the key to "START" position and
release when the engine starts.
9. Check to see that all the indicators on
the Easy Checker(TM) are "OFF".
10. Release the clutch pedal.
To Next Page
Loading...
Need help?
General
