Kubota u25 User Manual

59TROUBLESHOOTING
LCD Display LED Problem / Error Solution #1 Solution #2
9
Clock setting request
Power was interrupted
and the clock now has
to be set again.
In order to set the
clock, press the user
setting switch.
---
10 --- --- --- --- ---
11
Raise the control lever
lock
(yellow)
This message
indicates a step in a
procedure.
Raise the lock lever
(unload lever); the
indicator goes out.
---
12 --- --- --- --- ---
13
Lower the control lever
lock
(yellow)
This message
indicates a step in a
procedure.
Lower the lock lever
(unload lever); the
indicator goes out.
---
14
Oil pressure too low
(red)
+
The engine oil
pressure is too low.
Stop the engine
immediately. The
engine may have
developed a fault.
Inform your
KUBOTA dealer
immediately.
15
Overheat
The machine is
overheated and must
cool off by idling.
Allow the machine to
cool off by idling. Do
not switch the
engine off as the
coolant could then
boil over.
Clean the
radiator and
check the
coolant. Refill
the radiator with
coolant by its
boiled-over
amount. Unclog
the radiator and
other
components
before use
again.
Check also the
hydraulic system
for oil leak and
other troubles.
If an oil leak is
found,
immediately
contact your
local dealer for
repair.

Kubota u25 Specifications

General

Engine Power	14.9 kW (20 hp)
Max Dig Depth	2, 620 mm
Max Reach	4, 740 mm
Max Reach at Ground Level	4, 690 mm
Transport Length	3, 990 mm
Transport Width	1, 490 mm
Transport Height	2, 490 mm