Kubota WSM User Manual

5-S17
ZD18(F) · ZD21(F) · ZD28(F), WSM
ELECTRICAL SYSTEM
[4] LIGHTING SYSTEM
(1) Checking
Charge Lamp (Charging Circuit)
1. Remove the under panel.
2. Disconnect the 6P connector from the regulator after turning the
main switch OFF.
3. Turn the main switch ON and connect a jumper lead from the
wiring harness connector terminal (Black) to the chassis.
4. If the charge lamp does not light, the wiring harness or fuse is
faulty.
W1024567
Engine Oil Pressure Lamp
1. Disconnect the lead from the engine oil pressure switch after
turning the main switch OFF.
2. Turn the main switch ON and connect a jumper lead from the
lead to the chassis.
3. If the engine oil pressure indicator lamp does not light, the wiring
harness is faulty.
W1024686
Engine Oil Pressure Switch Continuity
1. Measure the resistance with an ohmmeter across the switch
terminal and the chassis.
2. If 0 ohm is not indicated in the normal state, the switch is faulty.
3. If infinity is not indicated at pressure over 4.9 kPa (0.5 kgf/cm
2
, 7
psi), the switch is faulty.
W1024804
(1) Regulator (a) From Charge Lamp
(1) Engine Oil Pressure Switch (a) From Oil Pressure Lamp
Resistance
(Switch terminal -
Chassis)
In normal state 0 Ω
At pressure over approx.
4.9 kPa (0.5 kgf/cm
2
, 7 psi)
Infinity
(1) Engine Oil Pressure Switch
KiSC issued 04, 2009 A

Kubota WSM Specifications

General

Brand	Kubota
Model	WSM
Category	Lawn Mower
Language	English