G-19
ZD18(F) · ZD21(F) · ZD28(F), WSM
G GENERAL
[4] CHECKING POINTS OF INITIAL 200 HOURS
Changing Transmission Fluid
CAUTION
• Be sure to stop the engine before changing the transmission
fluid.
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case and drain the oil completely.
3. After draining, screw in the drain plug.
4. Fill new oil from filling port after removing the filling plug (3) up to
the upper notch on the dipstick.
5. After running the engine for a few minutes, stop it and check the
oil level again, if low, add oil to prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-7.)
• Never work the machine immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes prevents damage to the transmission.
• Do not mix different brands oil together.
W1048918
Cleaning Transmission Strainer
When changing the transmission fluid, disassemble and rinse the
strainer with nonflammable solvent to completely clean off filings.
Check O-rings (3), replace if damaged, cracked or hardened.
When reassembling be careful not to damage the parts.
NOTE
• Since the fine filings in the oil can damage the precision
component parts of the hydraulic system, the end of the
suction line is provided with an oil strainer.
W1049356
Transmission fluid capacity (with filter and hose)
4.0 L
4.2 U.S.qts.
3.5 Imp.qts.
(1) Drain Plug
(2) Transmission Strainer
(3) Oil Plug and Breather Cup
(4) Dipstick
(A) Oil level acceptable within this
range.
(1) Strainer
(2) Suction Line
(3) O-ring
To Next Page
Loading...
Need help?
General
