2-S11
ZD18(F) · ZD21(F) · ZD28(F), WSM
TRANSAXLE
5. DISASSEMBLING AND ASSEMBLING
[1] SEPARATING TRANSAXLE
Draining Transmission Fluid
CAUTION
• Be sure to stop the engine before changing the transmission
fluid.
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case and drain the oil completely.
3. After draining, screw in the drain plug.
4. Fill new oil from filling port after removing the filling plug (3) up to
the upper notch on the dipstick.
5. After running the engine for a few minutes, stop it and check the
oil level again, if low, add oil to prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-7.)
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes prevents damage to the transmission.
• Do not mix different brands oil together.
W1015312
Battery
CAUTION
• When disconnecting the battery cables, disconnect the
negative cable from the battery first. When connecting,
connect the positive cable to the battery first.
1. Remove the battery cover (1).
2. Disconnect the negative cable (3) from the battery.
3. Disconnect the positive cable (2) from the battery.
W1015334
Transmission fluid capacity
4.0 L
4.2 U.S.qts.
3.5 Imp.qts.
(1) Drain Plug
(2) Transmission Strainer
(3) Oil Plug and Breather Cup
(4) Dipstick
(A) Oil level acceptable within this
range.
(1) Battery Cover
(2) Positive Cable
(3) Negative Cable
To Next Page
Loading...
Need help?
General
