Kubota WSM User Manual

G-17
ZD18(F) · ZD21(F) · ZD28(F), WSM
G GENERAL
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
may cause burns.
1. Remove the engine oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the rubber gasket of new cartridge.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the cartridge has been replaced, the engine oil level
normally lowers a little. Add engine oil to proper level. Check for
oil leaks around filter gasket.
IMPORTANT
• To prevent serious damage to the engine, element of
recommended type must be used. Use only a genuine
KUBOTA filter or its equivalent.
W1030949
Replacing Transmission Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow transmission case to cool down sufficiently; oil can be
hot and may cause burns.
1. The oil filter cartridge must be changed every 300 service hours.
2. Remove the oil filter cartridge with the filter wrench.
3. Lightly tighten the screw (2) by using a screwdriver.
4. Apply a slight coat of oil onto the cartridge gasket.
5. To install the new cartridge, screw it in by hand.
Over tightening may cause deformation of rubber gasket.
6. After the new cartridge has been replaced, the transmission fluid
level normally lowers a little. Add fluid to proper level. Check for
oil leaks around filter gasket.
IMPORTANT
• To prevent serious damage to hydraulic system, the
replacement filter must be a highly efficient, 10 μm filter.
Use only a genuine KUBOTA filter or its equivalent.
W1031068
(1) Engine Oil Filter Cartridge
(1) Transmission Oil Filter Cartridge (2) Screw
KiSC issued 04, 2009 A

Kubota WSM Specifications

General

Brand	Kubota
Model	WSM
Category	Lawn Mower
Language	English