－－16－－16
(10) HORN/LIGHTS INSPECTION(10) HORN/LIGHTS INSPECTION
Turn the ignition switch to the "ON" position and push theTurn the ignition switch to the "ON" position and push the
horn button to check if it sounds.horn button to check if it sounds.
Headlight/Taillight Inspection:Headlight/Taillight Inspection:
Start the engine and turn on the headlight switch to checkStart the engine and turn on the headlight switch to check
if the headlight and taillight are good and check the lightif the headlight and taillight are good and check the light
shells for dirt and damage.shells for dirt and damage.
Stoplight Inspection:Stoplight Inspection:
Apply the front and rear brake levers respectively to checkApply the front and rear brake levers respectively to check
if the stoplight is good. And also check the stoplight shellif the stoplight is good. And also check the stoplight shell
for dirt and damage.for dirt and damage.
Turn Signal Light Inspection:Turn Signal Light Inspection:
Operate the turn signal switch to make sure whether theOperate the turn signal switch to make sure whether the
right/left front and rear turn signal lights can wink andright/left front and rear turn signal lights can wink and
buzz. Also check the light shells for dirt and damage.buzz. Also check the light shells for dirt and damage.
Headlight Taillight/ Stoplight Turn signal lightHeadlight Taillight/ Stoplight Turn signal light
Horn button
Replace any dirty or damaged lights with new ones to
avoid danger during riding.
Replace any dirty or damaged lights with new ones to
avoid
danger during riding.
CAUTION:
To Next Page
Loading...
