KYMCO Mongoose/KXR 250 User Manual

3. INSPECTION/ADJUSTMENT
3-18
Mongoose/KXR 250
DRIVE SELECT LEVER
ADJUSTMENT
Turn the ignition switch is ON and make
sure the engine stop switch in the OFF
position.
Loosen the lock nuts of rod.
Shift the gear to neutral by moving the shift
lever and/or turn the rod. (The neutral
indicator lamp comes on.)
Provide standard/phillips screwdriver and
pass the standard/phillips screwdriver
through the shift arm into the index hole at
the transmission case cover.
Turn the rod clockwise or counterclockwise
until the drive select lever into the "N"
position of the shift guide and tighten the
lock nuts, then pull out the standard/phillips
screwdriver.
After adjustment, start the engine and test to
ride the ATV to be sure the drive select
lever is operating properly.
Lock Nuts
Rod
Standard/Phillips Screwdrive
r
Shift Ar
m
Index Hole
Drive Leve
r
Rod

KYMCO Mongoose/KXR 250 Specifications

General

Brand	KYMCO
Model	Mongoose/KXR 250
Category	Offroad Vehicle
Language	English