42
MAINTEN ANCE
Transmission f luid change
1. Place the scooter on its main stand.
3. After the fluid has drained out, reinstall the drain bolt with a
new sealing washer and tighten it to the specified torque.
2. Place a suitable container (drain pan) under the transmis-
sion case on its left side. Remove the drain bolt 1 to
drain the fluid.
11
11
1
22
22
2
33
33
3
Transmission fluid type: SAE 90
Transmission fluid capacity: 0.12 qt (0.11 L)
NOTE: The fill amount specified is the amount to use after
completely draining the used transmission fluid.
6. Install the transmission fluid filler bolt with a new sealing washer
and tighten it to the specified torque.
Transmission fluid filler bolt torque: 15 lb-ft (20 N-m)
Transmission fluid drain bolt torque: 15 lb-ft (20 N-m)
4. Remove the transmission fluid filler bolt 2.
5. Add the exact specified fluid through the fluid filler hole 3.
Using the wrong transmission fluid type or viscosity
may cause premature transmission component wear.
Do not exceed the specified amount when adding trans-
mission fluid. If too much fluid is added to the trans-
mission case it could be forced into the air cleaner as-
sembly during operation, causing air filter contamina-
tion and poor engine performance.
22
22
2
To Next Page
Loading...
Need help?
General