2-3
Connecting and Printing
Connecting the Power Cord
Install the printer close to an AC wall outlet. If an extension cord is used, the total length of the power cord plus extension
should be 5 meters (16 feet) or less.
1 Connect the power cord to the power cord connector at the rear of
the printer.
2 Connect the other end of the power cord to a power outlet.
3 (For Korean models) Turn the main power switch On.
4 Press the power switch to On. The printer begins to warm up.
Starter Toner Container
The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of
700 pages (FS-1040/FS-1041) or 1,000 pages (FS-1060DN/FS-1061DN).
Altitude Setting
If you are using the machine at an altitude of 1500 meters (480 feet) or higher and print quality has deteriorated, the
Altitude setting can be used to restore print quality. For more information, refer to KYOCERA Client Tool User Guide.
Note Only use the power cord supplied with the printer.
IMPORTANT If you install the toner container and switch on the
power, the Processing indicator and Attention indicator will blink
once simultaneously, and then blink alternately. When the printer
is first switched on after toner installation, there will be a delay of
approximately 7 minutes before the printer gets ready to print.
Once the Processing indicator lights, printer installation is
complete.
To Next Page
Need help?
General