EasyManuals Logo
Home>Kyocera>All in One Printer>FS-4300DN

Kyocera FS-4300DN User Manual

Kyocera FS-4300DN
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
Maintenance
7-2
Toner Container Replacement
The printer displays messages at two stages of toner usage:
When the printer becomes low on toner, the printer displays the message Toner is running out. as the first
caution. Note the replacement is not always necessary at this stage. Prepare the new toner kit.
If you ignore the above message and continue printing, the printer displays the message Replace the toner. - just
before the toner is used up. The printer will stop printing. The toner container must be replaced immediately. Refer to
Replacing the Toner Container on page 7-3.
Frequency of Toner Container Replacement
The life of the toner containers depends on the amount of toner required to accomplish your printing jobs. According to ISO/
IEC 19752 and EcoPrint switched off the toner container can print as follows (A4/Letter paper is assumed):12,500 images
(FS-2100D and FS-2100DN), 15,500 images (FS-4100DN), 21,000 images (FS-4200DN for the U.S.A.) or 25,000 images
(FS-4200DN for destination other than the U.S.A. and FS-4300DN).
Starter Toner Container
The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of
6,000 images (FS-2100D and FS-2100DN), 8,000 images (FS-4100DN) , or 10,000 images (FS-4200DN and FS-4300DN).
Toner Kits
For best results, we recommend that you only use genuine Kyocera Parts and Supplies. Should any damage be caused by
the application of a toner other than the original toner, then this damage is excluded from the guarantee.
A new toner kit contains the following items:
Toner Container
Plastic waste bags for old toner container and old waste toner box
Waste Toner Box
Installation Guide
Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to
improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather
information to support new product planning and development. The information gathered is anonymous - it cannot
be associated to any specific individual and the data is intended to be used anonymously.
Note Do not remove the toner container from the carton until you are ready to install it in the printer.

Table of Contents

Other manuals for Kyocera FS-4300DN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS-4300DN and is the answer not in the manual?

Kyocera FS-4300DN Specifications

General IconGeneral
ColorNo
Duplex printingYes
Print technologyLaser
Maximum resolution1200 x 1200 DPI
Time to first page (black, normal)9 s
Print speed (black, normal quality, A4/US Letter)60 ppm
Mobile printing technologiesNot supported
Printing colorsBlack
Maximum duty cycle275000 pages per month
Number of print cartridges1
Page description languagesEpson LQ, IBM ProPrinter, Microsoft XPS, PCL 5c, PCL 6, PCL XL, PDF 1.7, PostScript 3
Processor model465
Processor familyPowerPC
Compatible memory cardsSD, SDHC
Maximum internal memory1280 MB
Sound power level (standby)27.4 dB
Sound pressure level (printing)56.1 dB
Total input capacity600 sheets
Total output capacity500 sheets
Maximum input capacity2600 sheets
Total number of input trays2
Maximum number of input trays6
Multi-Purpose tray input capacity100 sheets
Custom media width70 - 216 mm
Maximum print size216 x 356 mm
Custom media length148 - 356 mm
Paper tray media typesPlain paper
Paper tray media weight60 - 120 g/m²
Non-ISO print media sizesLetter
ISO A-series sizes (A0...A9)A4, A5, A6
ISO B-series sizes (B0...B9)B5
Maximum ISO A-series paper sizeA4
Multi-Purpose Tray media weight60 - 220 g/m²
Standard interfacesEthernet, USB 2.0
Mac operating systems supportedMac OS X 10.4 Tiger, Mac OS X 10.5 Leopard, Mac OS X 10.6 Snow Leopard, Mac OS X 10.7 Lion, Mac OS X 10.8 Mountain Lion
Server operating systems supportedWindows 2000 Advanced Server, Windows 2000 Server, Windows MultiPoint Server 2011, Windows SBS 2011 Essentials, Windows SBS 2011 Standard, Windows Server 2003, Windows Server 2003 R2, Windows Server 2003 x64, Windows Server 2008, Windows Server 2008 R2, Windows Server 2008 x64, Windows Server 2012
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)13.1 W
Power consumption (printing)757 W
Power consumption (PowerSave)1.6 W
DisplayLCD
CertificationTÜV/GS, CE
Product colorBlack, White
Sustainability certificatesBlue Angel, ENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Depth416 mm
Width380 mm
Height320 mm

Related product manuals